No announcement yet.

Serial Port setup

  • Filter
  • Time
  • Show
Clear All
new posts

  • Serial Port setup

    I have two rotators. The HRD Rotator program thinks they are on com13 and com20. I only have com7, com10, com11, and com12 available on my computer. How do I change this??

    I have looked in the manual, but can't seem to figure it out. Thanks --

  • #2
    Well this is disappointing. In over a month there have been no responses. I really would like to have some help. I can't seem to find where or how to set the com ports for rotator control. Is there someone in the world who can tell me how to set comports for rotators? Of course HRD would like me to pay them for support. Too bad. They have my money and now they won't help...sad.


    • #3
      Sorry I can't help you since I don't have a rotator so I don't know about setting up the com ports. But, If you want support from HRD personnel, then you should go to and enter a new ticket.

      73, Charlie, K0LAF
      Charlie, KØLAF